Hardware Setup

Connect a registered RS-232 HART modem between the Serial Port marked “RS232-0” on the HART Test Appliance and the Maintenance Port of the WirelessHART device to be tested. (Refer to B in Figure 1 for the location of “RS232-0”).


Connect one Access Point (Figure 1: E) to the HART Test Appliance (Figure 1: C ) via the supplied USB cable (Figure 1: G). The USB cable could also be plugged into the front of the Test Appliance as an alternative.


Attach an antenna (supplied) to this Access Point. (Refer to Figure 1: F).


Depending on the HART Test System version, the location and type of connections may vary. The newest hardware configuration is shown in Figure 1A. The red/white hardware configuration is shown in Figure 1B.


Figure 1A. System Connections


Figure 1B. System Connections


Running Test Applications

To run a wireless (TML) test, open a linux terminal on the Test Appliance, type “lstmlscr” (without the quotes) on the terminal to see the list of implemented TML tests. Then type the name of the test you wish to run (e.g., TML102A) on the command line and press <Enter>.